Home > Automotive > How to Install Offroad Lights on Your Vehicle

How to Install Offroad Lights on Your Vehicle

When surrounded by wilderness after an exciting day of off-roading, merely relying on standard headlights to direct you back to hard roads might not be sufficient. Off-road lights come in various forms and dimensions, encompassing options like roof-mounted light bars, bumper-mounted spotlights, and grille-mounted lights. 

In this blog, we’ll take you through the steps to wire your new lights, ensuring they’re set up and ready for use instantly when required.

Select a Light that Suits Your Requirements

Identify your requirements. Your off-roading conditions and habits should guide your needs. If high-speed driving is your preference, then long-range roof-mounted lights would be ideal.

For low-speed ventures such as navigating rough trails or rock crawling, XK Glow lights mounted on the bumper or grille would be the most suitable. If your off-roading involves various activities, you may consider installing multiple lights on your vehicle.

Do not overlook the quality of the lights you are opting for. Go through online reviews to ensure the lights are appropriate for your intended use and will endure the conditions they will face.

Be cautious: It’s hazardous to other drivers to have offroad lights on while driving on the highway, as they can be blinding. In many localities, driving on roads with your offroad lights on is illegal and punishable by fines. If your lights aren’t covered, you might even get ticketed in some areas.

See also  6 Factors That Make E-Bikes Better Than Ordinary Bikes

Check Your Measurements Twice Before Executing a Single Cut

After assembling all the necessary equipment for your off-road lighting, it’s crucial to strategize your setup before making any drillings. 

This process assists in gauging the length of your wiring, formulating a plan for the direction of the wiring, and granting you the opportunity to test your lights before finalizing the installation. Determine the desired spot for your lights and confirm the precise positioning. 

During the staging phase of your lighting, it’s key to observe how the manufacturer routed the wiring and replicate it as closely as you can. Avoid squeezing your wiring or positioning it near a heat source.

Set Up Your Switch

When setting up your switch, choose a conveniently reachable position from the driver’s side of the vehicle. Ideal spots could be on the center console, beneath the radio, or on the dashboard where it won’t obstruct but remains within easy reach. Pick a switch that can accommodate all the lights you intend to install.

Opt for a spot where you feel confident drilling a hole, which will be necessary for the wiring installation. After pinpointing your location and drilling your hole, thread your wiring through it.

One wire should lead to the battery’s positive terminal to power the switch, while the other should connect to the light, supplying the necessary energy to light them up.

Connect Your Lights

Attach the wires to your lights. The lights will come with a black ground wire and another wire that powers the lights. Link the wire from your switch to the power wires of your lights. If connectors are provided with your lights, use them.

See also  How to Care for Your Car’s Most Easily Damaged Parts

If your lights don’t include connectors, use your wire strippers to expose half an inch of bare wire at the end of each power wire. Insert each end into a crimp-style wiring connector. Use a crimping tool or a pair of pliers to compress the connector onto the wires. Ensure you squeeze hard enough to secure the wires inside the connector.

Repeat the same process with the ground wires if they don’t have a harness. Attach the end of the ground wire to a concealed bare metal spot, either under the dashboard or under the hood. You can either use a pre-existing spot or drill a new one and fasten the ground wire with a screw.

Endnote

After you’ve set everything up, reconnect your battery and give your lights a try! If they light up when you flip the switch, then congratulations, you’ve successfully installed your off-road lights! To check the direction of your light beam, position yourself about 20 feet away with the lights turned on. Adjust the angle to ensure its pointing where you want it to.

Related Posts